If you're installing the default Intel or AMD heat sink fan for the first time, then there is no need to apply any thermal compound. You can see the three grey stripes of pre-applied thermal paste in the image below:. If you're installing a stock cooler than has been used before or an aftermarket heatsink fan, then it's a must to apply thermal compound to the CPU before proceeding - Click here to learn how to apply CPU thermal grease.
Begin CPU fan installation by making sure that all four push pins are facing the correct direction. The grooves on the push pins should be facing the center of the CPU fan see image below :. To install a CPU fan and heat sink, you will need to align the four push pins of the heat sink circled in yellow above with the four pin holes on the motherboard circled in yellow below :.
If the fan has not been attached, carefully fasten the fan and heat sink together by using the screws that came with the device. Step 4 Attach the heat sink and fan to the CPU. Some fans and heat sinks attach to the CPU chip with a number of clips. Attach the fan gently with an even amount of force.
Make sure not to damage the CPU and the motherboard of the computer. Search for a label 'fan' or 'CPU fan. How to Remove Trojan Virus from Computer. Choose an appropriate CPU fan and heat sink. Shut down the computer and open the casing so that the CPU is exposed. As a hot object transfers some of its heat to air molecules on its surface, it cools slightly. These hot molecules will move out while the air moves, allowing colder air to replace them and consume more heat.
From the back, align the bracket such that the pins poke into the holes. By now, I should loosely attach it. We consider doing this outside of the situation once more. It is the most straightforward method. To find the correct screws, consult the manual. The bracket is now fixed by screwing these support screws onto the four pins. The thermal paste comes pre-applied on most new coolers, so if yours does, you can skip to the next level.
The cooler does not obstruct your RAM slots, nor should it be so tall that it brushes against your case. If your CPU cooler is directly screwed in, align the screws with the bolts you previously connected and begin screwing. Begin attaching the bolts on opposite corners until the screws have passed cleanly into the holes. Use a Phillips head screwdriver to tighten these bolts properly. Many air coolers come with a fan already mounted.
If you wish to substitute the fan with a personal one, now is the time to do so. The fan cable connects to a four-pin header on the Motherboard.
0コメント